Advent DV1418A User Manual page 12

Audio Set Up:
By pressing MENU button ,and then pressing VOL(-/+) button it will bring you to Audio
Set Up display. Youwill see the following menu on your TVscreen:
Audio
VoIur'_'l_
_5
Follow the procedure below to adjust the sound quality:
Press VOL(4-) button to increase and VOL (-)button to decrease the level to your
preference.
Clock SetUp:
By pressing MENU button ,and then pressing VOL(-/4.) button it will bring you toAudio
Set Up display. You will see the following menu on your TVscreen:
Timer
Clock 17:18
Ch: Switch I
Follow the procedurebelow to selectone of theabove options:
1.Press the CH(+) and CH(-) button to go up and down the menu.
2.Press VOL(+) button or VOL(-) button to select your preference.
Clock: Press VOL(-) button forHOURS and VOL(4,)button for MINUTESadjustment.
Time-On: PressVOL(-) button forHOURS and VOL(4,) button forMINUTES adjustment.
This featureworks likean alarm clock. Your TVwill turn on atthe set time.
Ch. select: This exclusive feature switches you to your favorite channel at the
appropriate set time. PressVOL(+) and VOL(-) buttons to select the channel.
Time-Off : Press VOL (-) button forHOURS and VOL(4.) button for MINUTES
adjustment. Thisfeature works like an alarm clock. YourTV will turn off at the
set time.
Sleep time: This feature allows you to turn off television in pre-selected minutes (180,
170,160 .......... 10 and0). To cancel, keep pressing button untilyou exit out.
Remind time: Press VOL(-) button to set HOURS of attention and VOL(+)button
to set MINUTES of attention. You will see the flashing time on your TV when the
the reminder time arrives. Note: This exclusive feature can remind you of
important chores while watching TV.(e.g. Time to take pills, time to check
cooking, time tocall , timeto do homework ,etc.)
Ch. Switch: This feature lets you store yourfavorite channel. Once you store the
channel number in this function, when the set time is up, itwill switch over
to theset channel. This feature isused with theExchange feature. Press
VOL(+) orVOL(-) button to select the channel.
@