Projecting An Image; Selecting The Input Signal; Adjusting The Image - Panasonic PT-AE7000U Operating Instructions Manual

Projecting an image

Check the connections of the external devices
(  page 26) and the connection of the power cord
(  page 28), and switch on the power (
to start projecting. Select the video for projection, and
adjust appearance of the projected image.

Selecting the input signal

1) Switch on the external devices.
Press the play button on an external device, such
z
as a Blu-ray player. When [AUTO SEARCH] in the
[OPTION] menu is [ON], the projector automatically
searches for an input signal and starts projection.

( page 74)
2) Switch the video input.
The video selected with the <INPUT SELECT>
z
button is projected. (
Attention
The video may not be displayed properly depending on
z
the external device or the DVD being played back. In
such cases, set [TV-SYSTEM], [RGB/YC
YP P ] of the [ADVANCED MENU]. (
B R
Check the projection screen and video aspect ratio, and
z
select the most appropriate aspect ratio with [ASPECT]
in the [POSITION] menu. (

Adjusting the image

1) Adjust the angle of the projector.
Place the projector parallel to the screen, and
z
then install it on a flat surface so that the screen
becomes rectangle.
If the screen is tilted lower than the screen, extend
z
the adjustable feet to make a rectangle screen.
For details, see "Front adjustable feet and throwing
z

angle". ( page 23)
2) Remove the lens shift cover.
For details, see "Opening the lens shift cover".
z

( page 19)
3) Rotate the lens shift lever in a
counterclockwise direction to disengage
the shift lever lock.
 page 29),

page 34)
C ] or [RGB/
B R
 page 45)

page 58)
Projecting an image
4) Adjust the lens shift.
Adjust the projection position with the shift lever.
z
See "Lens shift and positioning". (
z
5) Rotate the shift lever clockwise to fix.
6) Attach the lens shift cover.
7) Managing the lens control settings
Press +/− of the <FOCUS> and <ZOOM> buttons
z
on the device controls to adjust.
Press the <FOCUS> buttons (+/-) to change the
projection size, and press the <ZOOM> buttons
(+/-) again to fine tune the projection size.
Note
It is recommended that you display the [ZOOM/FOCUS]
z
test pattern from the [LENS CONTROL] menu to
accurately adjust the focus (
be performed with the remote control. (
When displaying 3D video, press the <ZOOM> and
z
<FOCUS> buttons on the device controls to adjust.
Panasonic recommends that focus adjustment be made
z
after 30 minutes or more have elapsed since picture
display.
When viewing a 3D video, keystone correction is not
z
available. So that no keystone distortion occurs, place
the projector parallel to the screen, and then install it on a
flat surface so that it can project within the range of lens
shift.

page 24)
<ZOOM> button
<FOCUS> button

page 69).This can also
 page 32)
ENGLISH - 31