Temp And Lamp Indicators; Managing The Indicated Problems - Panasonic PT-AE7000U Operating Instructions Manual

TEMP and LAMP Indicators

TEMP and LAMP Indicators

Managing the indicated problems

If a problem should occur with the projector, the lamp indicator <LAMP> and/or temperature indicator <TEMP>
will illuminate or flash. Check the indicator status and deal with problems as follows.
Attention
When switching off power to deal with problems, ensure that you follow the procedure in "Switching off the power".
z

( page 30)
Note
Check the status of the power supply with the power indicator <ON (G)/STANDBY (R)>. (
z
Temperature indicator
■ Temperature indicator <TEMP>
z
Indicator
status
z
Problem The temperature inside and/or outside the projector is abnormally high.
The air intake and
Cause exhaust ports may
be obstructed.
Remove object(s)
from the ventilation
Solution ports or clear the
area around the
projector.
Note
If the <TEMP> indicator is illuminated or flashes despite taking the actions above, please contact your dealer to have your
z
projector repaired.
80 - ENGLISH
Lamp indicator
Illuminates red during projection.
(Alert indicating [REFER TO THE "TEMP indicator" SECTION IN THE OPERATION MANUAL.] is
displayed.)
Flashing red when power is turned off (projection stops automatically).
The room
temperature may
be too high.
Place the projector
in an environment
with temperature
and humidity as
designated in the
specifications.
(
 page
The air filter unit
may be excessively
dirty and ventilation
may be poor.
Clean or replace
the air filter unit.
( 82)
 page
100)
 page 28)
The projector may be being
used at high elevations (1 400
m or more above sea level).
The projector can only be
used for two minutes after
turning on. Set [HIGH
ALTITUDE MODE] to [ON]
within two minutes of turning
the projector on.
( 76)
 page