Specifying the projector(s) that will respond to the remote control when multiple projectors are used
When the projector is being used together with several others, the
projector that responds to the remote control can be limited as
described below.
1: Using the configuration menu, set a
projector ID.
Projector ID: 1
ID of projector
to be operated: 2
2: Using the remote control, set the
ID of the projector to be
operated on each of the
projectors.
After making the above setting, only the following projector(s) can be
operated with the remote control.
• Those for which the "Projector ID" and "ID of projector to be operated"
are the same. (Ex.: The second projector in the above figure)
• When "0" is set as the "ID of the projector to be operated".
• The default for the "Projector ID" is "Off". The default
q
for the "ID of projector to be operated" is "0". When "0"
is set, the projector can be operated with the remote
control, regardless of the "Projector ID" setting.
• When the power to the projector is turned off, the setting
made for "ID of the projector to be operated" returns to
"0", such that it can subsequently be operated from the
remote control.
Projector ID: 2
Projector ID: 3
ID of projector
ID of projector
to be operated: 2
to be operated: 2
Setting the projector ID
Procedure
A
Press the [Menu] button and then, from the
configuration menu, select "Extended" - "Projector
ID". s "Using the Configuration Menu"
Using the remote control
See the guide displayed below the menu for more instructions.
20
p.30
Using the control panel