Program Change On/Off; Control Change On/Off - Yamaha Portable Grand NP-30 Owner's Manual

MIDI Functions

Program Change ON/OFF

Normally the NP-30/YNP-25 will respond to MIDI program change numbers received from an
external keyboard or other MIDI device, causing the same numbered voice to be selected on the
corresponding channel (the keyboard voice does not change). The NP-30/YNP-25 will normally
also send a MIDI program change number whenever one of its voices is selected, causing the same
numbered voice or program to be selected on the external MIDI device if the device is set up to
receive and respond to MIDI program change numbers. This function makes it possible to cancel
program change number reception and transmission so that voices can be selected on the NP-30/
YNP-25 without affecting the external MIDI device.
While holding down the
C#6 key. Pressing the C#6 key repeatedly toggles between Program Change On
and Off.

Control Change ON/OFF

Normally the NP-30/YNP-25 will respond to MIDI control change data received from an external
MIDI device or keyboard, causing the voice on the corresponding channel to be affected by pedal
and other "control" settings received from the controlling device (the keyboard voice is not
affected). The NP-30/YNP-25 also transmits MIDI control change information when the pedal or
other appropriate controls are operated.
This function makes it possible to cancel control change data reception and transmission so that,
for example, the NP-30's/YNP-25's pedal and other controls can be operated without affecting an
external MIDI device.
While holding down the
D6 key. Pressing the D6 key repeatedly toggles between Control Change On and
Off.
26
NP-30/YNP-25 Owner's Manual
and
[SONG W W W W /A A A A ] [GRAND PIANO]
C#6
[SONG W W W W /A A A A ] and [GRAND PIANO]
D6
buttons, press the
NOTE
For information on program
change numbers for each of the
NP-30's/YNP-25's voices, refer to
MIDI Data Format on page 28.
Default setting: ON
buttons, press the
NOTE
For information on control
changes that can be used with
the NP-30/YNP-25, refer to MIDI
Data Format on page 28.
Default setting: ON