Vent System Identification - White Mountain Hearth 1 Installation Instructions And Owner's Manual

nstalling Vent Components (Figure 37)
I
Begin the vent system installation by installing the first Simpson
Duravent component, 90° elbow to the starting collars or straight
pipe on the top of the appliance, then the straight pipe length and
then horizontal or vertical termination kit.
NOTE: All outer connection joints must be sealed with aluminum
tape, screws or silicone sealant rated above 300°F/149°C. The
inner flue joints do not require any sealant.
Figure 37
Page 26
VENT SYSTEM IDENTIFICATION
ecial Venting Components (Simpson Duravent)
Sp
See Empire Comfort Systems Retail Price List for Simpson Duravent part
numbers and pricing.
DVVK-4FV
DVVK-4VP
(DVVK-4V)
DVVK-4TP
(DVVK-4T)
DVVK-4RP
(DVVK-4R)
DVVK-4RE
DVVK-4TSP
(DVVK-4TS)
Simpson Duravent vent system components lock into place by
sliding the concentric pipe section with four (4) equally spaced
interior beads onto the appliance collar or previously installed
component end with four (4) equally spaced indented sections.
When the internal beads of each starting outer pipe line up, rotate
pipe section clockwise 90° (approximately 3 inches). The vent pipe
is now locked together.
Continue adding components per the pre-planned vent system
configuration. Be certain that each succeeding vent component
is securely fitted and locked into the preceding component in the
vent system.
WALL THIMBLE
(MAXIMUM OF
TWO 90 ELBOWS)
Special DV Vent Kits
Available from Empire Comfort Systesm, Inc. dealers
Vertical Flex Vent Kit 4" x 7"
Direct-Vent Fireplace Vent Kit - Vertical, Includes SD-991,
SD-953, and SD-943
Direct-Vent Fireplace Vent Kit for Top Vent, Thru-the-wall,
8 to 11 inch wall thickness, Includes SD-911, SD-985,
SD-990 and SD-942
Direct-Vent Fireplace Vent Kit for Rear Vent, 5 to 7 inch
wall thickness, (standard thru-the-wall venting) Includes
SD-908, SD-985 and SD-942
Direct-Vent Fireplace Vent Kit for Rear Vent, Thru-the
wall, 5 to 7 inch wall thickness, (standard thru-the-wall
venting) Includes SD-908, SD985 and SD-942
Direct-Vent Fireplace Vent Kit for Top Vent, Thru-the-wall,
5 to 7 inch wall thickness, Includes SD-908, SD-985,
SD-990 and SD-942
VIB6A Vertical Inlet Baffle Kit for 6 5/8" diameter.
VIB7A Vertical Inlet Baffle Kit for 7" diameter.
(MAXIMUM OF
THREE 90 ELBOWS)
23552-4-0408