Operation - Thermador HGEW 36 FS Use And Care Manual

OPERATION
IMPORTANT: The most effective method of
removing vapors produced during cooking
is to:
[] Switch the ventilator ON prior to
cooking or as soon as you begin
cooking.
[] Switch the ventilator OFF
a few minutes after you have finished
cooking.
[] Set the glass plate in cooking
position.
//
Display for fan setting
cooking position
Fan follow-on
Light Reduce fan Fan ON and
speed increase speed
Fan OFF
Acoustic signal:
[] When a button is pressed, this is verified
by an acoustic signal.
Switching off the acoustic signal:
[] Simultaneously press buttons 0 and +
until a signal is emitted after approx. 3
seconds.
Switching on the acoustic signal:
[] Repeat the process.
Switching the fan ON
[] Press the + button or pull out the filter
drawer.
Setting the required fan speed:
[] Press the + button.
The fan speed is increased by one step.
[] Press the - button.
The fan speed is reduced by one step.
Switching the fan OFF:
[] Press the 0 button.
The displayed ,__ goes out shortly
afterwards.
Or:
[] Keep pressing the - button until the fan
switches off.
The displayed ,__ goes out shortly
afterwards.
Intensive setting:
Maximum power is obtained at the
intensive setting.
It is only required for short intervals.
[] Keep pressing the + button until a P
appears in the display.
[] If the intensive setting is not cancelled by
hand, the
fan will automatically switch back to step
2 after 10 minutes.
Fan follow-on:
[] Press the -->1 button or push in the filter
drawer.
The fan runs for 10 minutes at setting 1.
At the same time a dot flashes in the
display.
Then the fan switches off automatically.
Lighting:
[] Briefly press the .,,6. button to switch the
light on and off.
[] The light can be switched on at any
time, even though the fan is switched off.
[] Adjusting the brightness:
Hold down the .,,6. b utton until the
desired brightness is obtained.