C Playback; Normal Playback; Tracking Adjustment; Slow Motion - Emerson EWC27T4 Owner's Manual

NORMAL PLAYBACK

Make sure ...
•
TV/VCR/DVD power must be turned on.
1
Insert a prerecorded tape
If the erase-protection tab has been removed, the
TV/VCR/DVD will start playback automatically.
2
To begin playback
Press the PLAY button.
3
To stop playback
Press the STOP button when play-
back is completed.
NOTES:
•
If you press the PLAY button (of the TV/VCR side)
in the DVD mode, you can start the VCR playback.
•
If you press the SELECT button during the VCR
playback, it will stop and the mode will change to
the DVD mode. In addition, the same function
operates with the DVD side PLAY button or the
OPEN/CLOSE button.

TRACKING ADJUSTMENT

•
Tracking adjustment will be set automatically
(Digital Tracking function) when you start play-
back.
•
However when playing pre-recorded tapes or tapes
recorded on other VCR, noise lines (black and
white streaks) may appear on the playback picture.
If this occurs, you can adjust the tracking control
manually by pressing the CHANNEL button K or
L until the streaks disappear. To return to the DTR
function, stop the tape once and start playback
again.
•
You can reduce the noise lines by pressing the
CHANNEL button K or L in slow mode too.
Tracking adjustment in Slow mode will not be set
automatically.
PLAYBACK
TV/VCR
Press the PAUSE button, then press the F.FWD g
button to start the playback in slow motion. The
TV/VCR/DVD mutes the sound during slow motion.
Press the PLAY button to return to normal playback.
NOTE: If it is left in the Slow mode for more than
five minutes, the TV/VCR/DVD will automatically
go into the Stop mode.
PLAY B
You can view a still picture on the TV screen during
playback (the Still mode). Press the PAUSE button
during playback. Only tapes recorded in the SLP
mode will show the least amount of lines. Press the
PLAY button to return to playback.
STOP
NOTES:
•
You can advance the picture one frame at a time by
pressing the PAUSE button during the Still mode.
•
If it is left in the Pause mode for more than five
minutes, the TV/VCR/DVD will automatically
switch to the Stop mode.

VERTICAL HOLD CONTROL

In the Pause/Still mode only, when the picture begins
to vibrate vertically, stabilize the picture by pressing
the CHANNEL button K or L.
NOTE:
If there are video noise lines on the screen, see Tracking
Adjustment section.
TV/VCR
- 26 -

SLOW MOTION

STILL PICTURE

TV/VCR
TV/VCR
TV/VCR
EN
1C29