Internal Connectors - Asus P5QL-EM - Motherboard - Micro ATX User Manual

1.10.2. Internal.connectors
1.. Floppy.disk.drive.connector.(34-1.pin.FLOPPY)
This connector is for the floppy disk drive (FDD) signal cable. Insert one end of the
cable to this connector, then connect the other end to the signal connector at the back
of the floppy disk drive.
• Pin 5 on the connector is removed to prevent incorrect cable connection when using a
P5QL-EM.
2.. ICH10.Serial.ATA.connectors.(7-pin.SATA1,.SATA2,.SATA3,.SATA4,.SATA5,.
SATA6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
P5QL-EM.SATA.Connectors
Connect the right-angle side of SATA
signal cable to SATA device. Or you
may connect the right-angle side of
SATA cable to the onboard SATA
port to avoid mechanical conflict with
huge graphics cards.
1-22
FDD cable with a covered Pin 5.
Floppy.Disk.Drive.Connector
FLOPPY
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
SATA1 SATA2
GND GND
RSATA_TXP1 RSATA_TXP2
RSATA_TXN1 RSATA_TXN2
GND GND
RSATA_RXP1 RSATA_RXP2
RSATA_RXN1 RSATA_RXN2
GND GND
SATA3 SATA4
GND GND
RSATA_TXP3 RSATA_TXP4
RSATA_TXN3 RSATA_TXN4
GND GND
RSATA_RXP3 RSATA_RXP4
RSATA_RXN3 RSATA_RXN4
GND GND
SATA5 SATA6
GND GND
RSATA_TXP5 RSATA_TXP6
RSATA_TXN5 RSATA_TXN6
GND GND
RSATA_RXP5 RSATA_RXP6
RSATA_RXN5 RSATA_RXN6
GND GND
right-angle.side
Chapter 1: Product introduction