Asus P5P41T LE User Manual page 33

7. IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are
three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard's IDE connector, then select one of the
following modes to configure your device.
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices.
P5P41T LE
P5P41T LE IDE connector
If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the
same setting.
ASUS P5P41T LE
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
PRI_IDE
NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.
Mode of device(s) Cable connector
- Black
Master Black
Slave Gray
Master
Black or gray
Slave
1-23