Table of Contents
Advertisement
30
Installation
INSTALLATION INSTRUCTIONS
INSTALLATION
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Inlet water supply
• Cold water pressure: 800 kPa max - 50 kPa
min
• Water flow rate 10 L/minute min.
• If cold water pressure is in excess of 800 kPa,
a pressure-reducing valve should be used.
Check for leaks.
WARNING!
Make sure that mains plug is disconnected from the mains socket during installation.
CAUTION!
Obey the instructions in the enclosed template to:
• build-in the appliance,
• install the furniture door,
• connect to the water supply and drain.
Install the appliance under a counter (kitchen worktop or sink).
If a repair is necessary, the appliance must be easily accessible for the engineer.
Put the appliance adjacent to a water tap and drain.
For the venting of the appliance only water hoses and mains cable openings are necessary.
The appliance has adjustable feet to allow the adjustment of its height.
The hose s hould not be
extended by more than
2 metres or water pump-
out problems ma y occu r
Secure dishwasher with
brackets and screws provided
Gap on both sides should be
equal, & no greater than
5mm per side.
If floor is not level, adjust
levellin g legs to suit
Remove entire plastic
Fix drain hose max of
membrane from sink trap
10mm below the top of
spigot & fit drain hose to spigot
the dishwashe r
with clamp
600mm max.
300mm min.
POWE R S UPPL Y
230/240V - 1 0 Amps
Hide quick links:
Advertisement
Table of Contents
