Table of Contents
Advertisement
...there are problems operating the dishwasher.
Symptom
The programme does
not start.
Spots of rust are visible
in the washing com-
partment.
There is a whistling
noise during washing.
...the wash results are unsatisfactory.
The dishes are still dirty.
– The wrong wash programme was selected.
– The dishes were arranged in such a way as to stop the water reaching
all parts of the surface. The dish racks must not be overloaded.
– The filters in the base of the washing compartment are dirty or incor-
rectly positioned.
– Too little or no detergent was used.
– Where there are limescale deposits on the dishes: the special salt con-
tainer is empty or the water softener is incorrectly adjusted.
– The drain hose is connected wrongly.
The dishes are wet and dull.
– Rinse aid was not used.
– The rinse aid container is empty.
Possible Cause
The dishwasher door has not
been closed properly.
Mains plug is not
plugged in.
House fuse is faulty.
For dishwasher models with
delay start timer:
Delay start has been selected.
The washing compartment is
made of anticorrosive stain-
less steel. Rust spots in the
washing compartment are
from particles from outside
the appliance (rust particles
from the water pipe, from
pans, cutlery, etc.). Remove
such spots with a commer-
cially available stainless steel
cleaner.
The whistling is not a cause
for concern.
Operating Instructions
Solution
Shut the door.
Insert mains plug.
Replace fuse.
If dishes are to be washed
immediately cancel delay
start timer.
Only wash cutlery and dishes
that are suitable for dish-
washer use.
Close the salt dispenser lid
securely.
Use a different brand of
detergent.
31
Advertisement
Table of Contents
