Table of Contents
Advertisement
Operating Instructions
Start the wash pogram
0
1. Check that when the dishes and cutlery are loaded in the dishwasher
the spray arms are free to rotate.
2. Open the tap fully.
3. Shut the door.
4. Press the ON/OFF button. ON/OFF button indicator comes on.
5. Press the button for the programme required (see "Programme Table").
The programme indicator lights up. One or two lights will flash in the
multidisplay. During this time it is possible to reselect the programme.
The selected washing programme begins after approx. 6 seconds. The
current wash programme stage will always be shown in the multidis-
play.
If the top light and/or the middle light in the multidisplay flash after
3
the programme has started please read the section "What to do, if...".
Interrupting or ending the wash programme
Only interrupt a wash programme in progress if it is absolutely neces-
3
sary. After the appliance has been closed again the air that has entered
will be greatly heated and expand. As a result water may penetrate the
base of the appliance and trigger the anti-flood system.
Interrupting the wash programme by opening the door of the dish-
washer
Hot steam can escape from the appliance when the door is opened.
1
Open the door carefully.
1. Open the door of the dishwasher. The wash programme will stop.
0
2. Lights are flashing in the multidisplay.
3. Shut the door. The wash programme will continue.
Ending the wash programme
0
1. Press the button for the wash programme that is running and hold it
down until the programme indicator for the wash programme goes out.
2. Release the programme button; the wash programme has been ended.
26
Advertisement
Table of Contents
