Troubleshooting; Something Not Working - Electrolux ESF 45010 User Manual

30 electrolux something not working

Something not working

The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights,
which can be solved with the help of the indications described in the chart,
without calling out an engineer.
Switch off the dishwasher and carry out the following suggested corrective
actions.
Fault code and malfunction
continuous flashing of the light of the
running programme,
1 flash of the end of programme
indicator light,
The dishwasher does not fill with water
continuous flashing of the light of the
running programme,
2 flashes of the end of programme
indicator light,
The dishwasher will not drain
continuous flashing of the light of the
running programme,
3 flashes of the end of programme
indicator light,
Anti-flood device is activated
Possible cause and solution
The water tap is blocked or furred with
limescale.
Clean the water tap.
The water tap is turned off.
Turn the water tap on.
The filter (where present) in the threaded
hose fitting at the water inlet valve is
blocked.
Clean the filter in the threaded hose.
The water inlet hose has not been
correctly laid or it is bent or squashed.
Check the water drain hose connection.
The sink spigot is blocked.
Clean out the sink spigot.
The water drain hose has not been
correctly laid or it is bent or squashed.
Check the water drain hose connection.
Close the water tap and contact your
local Service Force Centre.