Thank you for purchasing an Earlex Outdoor Paint Sprayer. Please read all these instructions before operating this product and retain them for future reference. Earlex Ltd will accept no responsibility for the use of this product if used for any other purposes than those detailed herein.
Page 2
● socket for added protection against electric shock. not known. Stay alert - Watch what you are doing. Use common Use genuine Earlex parts only. ● ● sense and do not operate tool when you are tired. This appliance is not intended for use by persons ●...
PARTS AND ACCESSORIES 1. 1.0mm Nozzle SG209 4. Suction Tube and Filter Assembly SG240 2. 0.6mm Nozzle SG211 5. 1.0 Litre Paint Container SG242 3a. Valve Assembly - 3 parts SG612 6. Lubricating Oil SG244 3b. Piston Spring 55W SG612 7.
Page 4
PLEASE NOTE We have done all we can to ensure that used correctly and according to these instructions, the Earlex Outdoor Paint Sprayer will give long trouble free service. We accept no responsibility for damage...
Page 5
PREPARING AND USING YOUR PAINT SPRAYER Preparation of the surface and thinning of the paint are the two most important areas to be concerned with to obtain the best results from your Paint Sprayer. Ensure all surfaces are free from dust, dirt, rust and grease.
Page 6
USING THE OUTPUT CONTROL KNOB Turning the output control knob clockwise reduces the flow of material whilst turning it anti-clockwise increases the flow. To adjust the pattern undertake the following: 1. Turn the output control knob anti-clockwise to the maximum position. 2.
Fig.5 SPRAY NOZZLE SELECTION The Earlex Outdoor Paint Sprayer is supplied with 0.6mm and 1.0mm nozzles. 1) 0.6mm - This size works best for stains and water-proofers for small application areas. 2) 1.0mm - This nozzle is suitable for spraying woodcare treatments.
Page 8
● Rinse the Paint Sprayer Paint Container with the thinner that was used and spray through the Paint Sprayer onto cardboard or newspaper. ● Remove the top knob, slightly push the nozzle towards the switch and pull down and forward to release the piston cylinder assembly from the main Paint Sprayer assembly.
A worn valve will cause a poor spray pattern and will require replacing. Replacement valves are available from the Earlex Service Department (see page 11 for contact details). You will need to check the spray nozzles, Piston and Spring from time to time to check for wear.
TROUBLESHOOTING PROBLEm cAuSE AcTION REQuIRED Paint Sprayer hums but Piston sticking (3c) Remove the large knob at the top of the unit. Pull Nozzle does not operate and Piston Assembly down and back to release from main gun assembly. Insert the metal punch (7), supplied in the spares pack, into the front of the cylinder housing and gently tap the punch to eject the seized piston.
This unit is a Class II appliance which means it is double insulated for your protection, no earthing wire is necessary. If the supply cord is damaged, it must be replaced by Earlex Ltd or our appointed agents. Your unit has been supplied with a mains lead with a fitted fused plug. Please read the following safety instructions before use.
Need help?
Do you have a question about the ASG55 and is the answer not in the manual?
Questions and answers