Dukane 8107HWI User Manual page 23

1.5 Selecting the network connection method (continued)
(3) Confi guring manually
After entering the Passcode (
confi guration manually if you use a Subnet mask other than Class A, B or C. (
If you use the wired LAN, go to (
Wireless LAN
The projector is required to be connected to an access point by a LAN cable.
1) The setting on the access point. *1
Enter the following information.
SSID : WirelessAccessPoint (example)
Encryption: WEP64bit (example)
Encryption key *2: ********** (example)
2) The setting on the projector. *3
Enter the following information.
Subnet mask *4: 255.255.255.128
(example)
3) Click the [Connect].
4) The wireless connection will be established.
Proceed to item 1.8 Confi rming the connection to your destination. (
*1 Contact the network administrator to fi nd out the setting on the access point.
*2 If you use an encryption, you need to set it. Contact the network administrator
to check the encryption key that is set in the projector.
The encryption key is always shown as " ********** ".
*3 To fi nd the network setting on the projector, refer to the NOTE. (
*4 If you use Subnet mask except Class A/B/C, please set it.
17), you are required to enter the network
22).
1. Connection to the network
15)
30)
22)
21