Recommended Accessories - Dremel 1680 Owner's Manual

Recommended Accessories

Use only Dremel accessories. Follow instructions that accompany accessories. Use of improper accessories may cause haz-
ards.
LEG SET
Cat. No.
16500 Scroll Saw Stand
Dremel offers both Plain and Pin-End 5 inch blades.
PIN-END
Pin-End blades permit relatively tight radius cutting in hard and soft wood.
Cat. No. Suggested Usage
16412 For cutting wood 3/8" to 2" thick
16411 For cutting wood 3/16" to 1" thick
16413 For cutting wood thinner than 1/4" thick
PLAIN-END
The Pin-End blades, while somewhat easier to put in and take out of the machine, do not always produce the same controlled
cutting action provided with the Plain-End blade. These narrow Plain-End blades allow the user to cut more detailed, intricate
patterns and smaller inside cuts.
Cat.No. Suggested Usage
16453 For cutting hard and soft woods 1/4" to 2" thick
16446 For close radius cutting in materials 1/8" or thicker
16443 For very tight radius work in thin materials, up to 1/8"
16440
16448
SPIRAL
Saws in all directions without turning the workpiece.
Cat. No. Suggested Usage
16461 For wood, plastic and abrasive materials
16463
METAL PIERCING
For cutting precious and non-ferrous metals; these must be used at very slow speeds. They perform well on machines
that have variable speed capability and should be lubricated with beeswax, or a light machine oil.
Cat. No. Suggested Usage
16483 Metals and other hardwood materials.
REVERSE TOOTH
Provides a smooth, splinter free finish. Eliminates the need for excessive finish sanding, and leaves a clean sharp edge on
both the top and bottom of your workpiece.
Cat. No. Suggested Usage
16431 For cutting hard or soft woods up to 1/8" thick.
16432 For cutting hard or soft woods 1/8" or thicker
16433 For cutting hard or soft woods 3/8" to 2" thick
PERMA-GRIT TUNGSTEN CARBIDE
Shapes and cuts ceramic tiles cleanly and accurately. Cuts intricate patterns easily in any direction. Also use for thin
wood. Not for use on ceramic floor tile.
Cat. No. Suggested Usage
16471 For very tight radius work in cearmic tile or thin wood.
16472 For close radius cutting in ceramic tile or thin wood.
Saw Blades
18.
Width Thick TPI
.110" x .018" x 10
.110" x .018" x 15
.070" x .010" x 18.5
Width Thick TPI
.062" x .020" x 9.5
.038" x .016" x 12.5
.029" x .012" x 20
.022" x .010" x 28
.045" x .017" x 11.5
Kerf TPI
.028" - .030" x 46
.034" - .036" x 41
Kerf TPI
.033" x .016" x 36
Kerf TPI
.029" x .012" x 20
.038" x .016" x 12.5
.047" x .017" x 11.5
Kerf Grit
.031" x .033" 60
.046" x .048" 120
Speed
Any
Any
Any
Speed
High
High
High
High
High
Speed
Any
Speed
Low
Speed
Any
Any
Any
Speed
Medium
Medium