Normal Cd Playback - Emerson HD8118 Owner's Manual

NORMAL CD PLAYBACK

• Make sure you have installed the batteries.
• Make sure the HOLD switch is set to the ' Off' (left) position.
• Make sure to set the VOLUME control to a low setting before you put on
the headphones.
IMPORTANT:
This CD player can play normal CDs plus CD Recordable (CD-R) and CD
Rewriteable (CD-RW) discs. However the playability of CD-R and CD-RW discs
may be affected by the type of software that was used in ' ripping' the tracks from
the original discs and ' burning' the tracks onto the blank media. Playability may
also be affected by the quality and condition of the blank media you use for
recording. 100% compatibility cannot be guaranteed. This is not an indication of
any problems with your player.
1.) Slide the CD door OPEN switch to the right to unlock
and open the CD door.
2.) Place your CD on the center spindle with the printed
label side facing up. Press downward on the disc
near the center hole until the disc is fully seated on
the spindle.
3.) Close the CD door and connect the headphones to
the headphone jack (green color) by pushing the
headphone plug the into headphone jack until a ' click'
sound is heard.
4.) Press the PLAY/PAUSE button to begin playback. The
display will briefly show "60 SEC", then " – – " flashes
while the player reads the disc. The total tracks and playing time will appear
briefly in the display and then the playback will begin on track 1. The display
will show the elapsed playing time of the track being played.
5.) Adjust the VOLUME, and BASS BOOST controls as desired.
HD8118_022004.p65
11
11
OPEN
20/2/2004, 11:37