Advertisement
Available languages
Available languages
13
Traction Drive
TRACTION DRIVE TENSION
Initial Adjustment
1. With the drive lever released there should be no slack
in the cable when moved slightly from side to side,
but bellcrank arm remains in fully down position.
1. To adjust tension on the cable loosen adjustment hex
nut (D, Figure 20) by holding the adjusting flats (A).
Turn the adjustment screw. The adjustment screw is
a phillips screw and the head can be held or turned
by inserting a screwdriver through the traction drive
clutch cable spring
3. Engage the drive lever to check the adjustment.
When correct, tighten hex nut securely. The unit
should able to be pushed forward and back freely.
Run-In Adjustment
1. After 5 hours of use, check for proper adjustment.
Readjust clutch cable if necessary by increasing ten-
sion on cable. A small amount of bellcrank arm move-
ment is permissible if unit passes operating checks
described in the Caution below.
WARNING
Do not over-tighten, as this may cause traction drive to engage without depressing the traction drive
control (bellcrank arm must remain in down position).
Verify that the cables are not over-tightened: With speed selector in position 1 and traction drive control
fully released, push snowthrower forward. The unit should move forward freely.
If unit does not move forward freely, the cable has been over-tightened. To remedy, loosen tension on
clutch cable slightly, and recheck.
8/2005
Intermediate & Large Frame Snowthrowers
A
C
Figure 20. Traction Drive Adjustment (Tube Handle
Models)
A. Adjusting Flats
B. Spring Hook
C. Bellcrank Arm
D. Nut
E. Adjustment Screw
11
D
E
B
TP 399-4222-01-LW-SN
Advertisement
