Bus Interface Module Setup; Information Menu; Odometer Preset Menu - Dakota Digital 3 Series Installation And Operation Manual

BUS INTERFACE MODULE SETUP

The bus interface modules (BIM) can be added to Dakota Digital instrumentation
systems. They allow you to add auxiliary gauge functions such as fuel pressure, vac/boost,
trans temp, etc., right into the system without having to add additional gauges. All of the BIM
readings are displayed on the tachometer message display where the tachometer and other
performance readings are currently displayed. Switch 2 (SW2) is used to cycle through the
various message screens.
More detailed instructions are supplied with the BIM units.

INFORMATION MENU

The information menu "INFO" is used to display software code information should you
have any trouble this information can be useful for troubleshooting as well as the current
speedometer calibration value if using the normal speed input (SPD SND).
• Press and hold SW1 while turning the key on.
• Release the switch and then press and release SW1 to get to the "INFO" setup menu. You
should see "SExx" on the speedometer display where xx is the software number.
• To view the current pulse per mile (PPM) setting, press and hold the SW1 until "-" "INFO" is
displayed.
• Release the switch and the odometer will show the current PPM setting/calibration value.
• Press and release the switch to go on to the next setup menu.

ODOMETER PRESET MENU

The control box will allow you to set the odometer reading to match your current odometer
reading, ONE time within the first 100 miles. Once the odometer has more than 100 miles,
this menu option will no longer be displayed. Make sure you have correctly selected the
units to be either MPH or km/h and calibrated your speedometer first. The odometer will
be set in the selected units. Once you have preset the miles you cannot change it again
without sending to the factory.
WARNING!!: This only allows setting odometer to the nearest mile. Do not use tenths!
For example a mileage of 65432.1 should be set to "065432" using this method. If the
tenths digit is used, the odometer will read 10 times too high.
• Press and hold SW1 while turning the key on.
• Release the switch and then press and release SW1 to get to the "-odom" setup menu.
• Press and hold the switch until "-" "odom" is displayed to enter the odometer setup menu,
then release SW1. The current miles will be displayed on the odometer with the left most
digit flashing.
• Press and release SW1 to increment the digit. Press and hold the switch to move to the next
digit to the right.
• Continue until the right most digit has been set. Press and hold the switch and the speed
display will show " nO"
• If the value is incorrect, press and hold the switch while " nO" is displayed to go back and
change the odometer miles or turn the key off to cancel any changes.
• If the value is correct, press and release the switch to change to speed display to "YES".
• Press and hold the switch while "YES" is displayed to save the current odometer reading and
return to the setup menus.
26 MAN 650066:E