Setting Up The Control Box - Dakota Digital 3 Series Installation And Operation Manual

Setting up the control box

Below is a list of all of the setup menus. You must have SW1 wired to enter setup;
descriptions of each menu are below. Pay close attention to Setup Menus and settings as
incorrect settings will cause faulty readings on the displays.
Main Menu
SPEED
Tach
VOLT
WATER
OIL
FUEL
PERF
NIGHT
BIM
INFO
-ODOM
To enter the setup mode, press and hold SW1 while turning the key/power on. The display
should light up and show SET SETUP on the speedometer and speed message displays.
Release the switch and SET SPEED should display, this is the start of the setup menus. Press
and release SW1 to advance through the main menus. A press and hold will enter the sub
menu. A press and hold is also used to save the setting and jump to the next option, or exit a
menu when DONE is displayed.
Sub Menu
SENDER (normal, bus)
AUTO
(MPH/KMH)
ADJUST(MPH/KMH, normal, bus)
Servic(OFF, 500 – 7500)
OUTPUT (2k ppm, 4k PPm)
DONE
T CAL (Bus,1 – 16)
UPDATE (slow, mid, fast)
WARN (2200 – 14800)
SIGNAL (5 LO, 12 HI)
DONE
WARN (10. 0 – 13. 1 )
DONE
SENDER (DD F,DD C,BUS F, BUS C)
WARN (150-300F / 65 -148c)
TEST
DONE
WARN (5 – 36)
TEST
DONE
SENDER (SW 33, CUSTOM,
GM 30, GM 90, GM 250,
F 10, F 150, V 180)
CUSTOM
TEST
DONE
On
Off
SCAN
SETUP
DONE
SExx
SPEED CAL PPM(on press/hold)
Description____________________
Select sensor type
Auto calibrate speed
Adjust the speed calibration
Select the service countdown
Select output speed signal PPM setting
Exit setup menu
Set engine cylinder count
Set rpm update rate
Set rpm shift warning point
Select rpm signal voltage level
Exit setup menu
Set low volt warning point
Exit setup menu
Select sensor type
Set high temp warning point
Display sensor ohm reading
Exit setup menu
Set low pressure warning point
Display sensor voltage reading
Exit setup menu
Select sensor type
Calibrate custom fuel sensor
Display sensor ohm reading
Exit setup menu
Enable performance readings
Disable performance readings
Change preset night dimming
Check/scan for connected modules
Enter setup (only when modules present)
Exit setup menu
Current software code
Current pulse per mile cal value saved
Used to preset odometer reading
16 MAN 650066:E