Projector Lights And Status - Smart Technologies SMART Board 480iv Configuration And User's Manual

C H A P T E R 6
Troubleshooting your interactive whiteboard system

Projector lights and status

Two indicator lights (Power and Service) are located on the bottom of the SMART V25 projector.
Specific light sequences convey information about the state of the projector, including errors.
I
I M P O R T A N T
After you resolve the projector's issue, disconnect and then connect the projector power cable to
clear the indicator light sequence, and then reset the projector's status (see Resetting the projector
on page 50).
Power light Service light
Solid red Off
Flashing green Off
Solid green Off
Flashing red Off
Off Flashing red
39
Message
The projector is off but still receiving power (Standby
mode). Press the Power
turn it on.
The projector is in the powering (startup) state. Wait for the
projector to finish turning on.
The projector is in the operating (on) state. Press the Power
button on the remote control twice to turn it off.
The projector is in the cooling state. Wait for it to finish
cooling.
The projector is overheating. It could shut down
automatically.
See The "Projector Overheated" message appears on the
next page to troubleshoot the projector.
button on the remote control to