Section 2: Using The Digital Depth Gauge; What You See On-Screen; Control Functions - Teleflex TFXIDD Operation Manual

USING THE DIGITAL DEPTH GAUGE

WHAT YOU SEE ON-SCREEN

WHAT YOU SEE ON-SCREEN
Figure 1

CONTROL FUNCTIONS

4
The digital depth gauge uses a backlit 7-
segment display in conjunction with a 3-button
keypad to control all user functions. At initial
power-up, the unit will begin normal operation
and display the digital depth and the units of
measure. Figure 1 shows a typical view you
might see on-screen at initial power-up.
The digital depth gauge uses 3 buttons to
control the Shallow Alarm, Deep Alarm, Keel
Offset, and Units of Measure function. While in
normal operation, pressing the SET button
selects a Function and blinks its corresponding
indicator on the display. Once a Function has
been selected it may be adjusted by pressing
the UP and Down arrow buttons to adjust the
setting. Further presses of the SET button will
sequentially select the other functions for
adjustment. All user settings are remembered
by the digital depth gauge, even when
powered off.
When in an active function, a single press to an
arrow button will result in a single incremental
adjustment. Pressing and holding an arrow
button will sequence through a range of
adjustments. If no adjustment is made for 5
seconds, the unit will return to normal
operation.