Teleflex TFXIDD Operation Manual page 15

If your Teleflex Digital Depth Gauge is a Rear Mount (
use a "rocker" or "toggle" type switch to control all
functions. While in normal operation, press and hold the
switch in any direction to scroll through all functions. A
function indicates it is selected by blinking. For example the
KO (Keel Offset) icon will blink, showing that it is the currently
selected function. Release the switch and the selected
"blinking" function will become active, ready for adjustment.
Once a function has been selected it may be adjusted
by toggling in either direction - one direction will increase
the setting and the opposite direction will decrease the
setting. "Entering" a selection is accomplished by not using
the switch for 5
seconds and also
returns the Teleflex
DDG to normal
RM
operation. Toggling
the switch again will
start a scroll through
functions, stop at
the next function
you need to adjust,
toggle to adjustment
value desired and let
time out for 5 seconds, setting value and returning to normal
operation. All user settings are remembered by the Teleflex
DDG , even when powered off.
RM
Function Control and Adjustment
Function Control Switch
Note: Not All digital depth gauge
installations use the same type of
switch,
instructions are given on how to
use the switch. The switch may also
be installed vertically or horizontally. It
is up to the user to determine which
direction toggles up and which
direction toggles down.
therefore only
) it will
RM
general