Listening To The Fm Radio - Altec Lansing Moondance HOME M302 User Manual

Listening to the FM Radio

1
Plug the FM radio antenna into the speaker system's FM
ANTENNA jack.
The jack is located on the back of the system.
2
Extend the FM antenna wire fully for best FM reception. Also,
do not strip, alter or attach to other antennas.
3
Ensure your speaker system is powered on.
If the system isn't on, press the STANDBY button on the speaker
system or the button on the wireless remote.
4
Select "FM" mode.
Press the SOURCE button on your speaker system or the SOURCE
button on the wireless remote until the FM appears on the LCD.
5
Tune to the station you want to listen to.
Use the and
desired station.
Press and hold these same buttons for 3 seconds to find the next
clear FM station. Press and hold the AUTO button on the wireless
remote for 3 seconds to automatically tune and save all clear FM
stations.
6
Adjust the volume.
Use the VOLUME + and – VOLUME buttons on the Altec Lansing
Moondance Home speaker system to adjust the system volume. Or,
use the VOLUME + and – VOLUME buttons on the wireless remote.
NOTE Extend the FM antenna wire fully for best FM reception. Also, do not
strip, alter or attach to other antennas.
12
buttons on the wireless remote to tune in the
How to Store Preset Stations
Your Altec Lansing Moondance Home speaker system's wireless remote
enables you to program up to 16 FM station presets:
1
Ensure your speaker system is powered on.
2
Make sure you are in "FM" mode.
3
Tune to the station you wish to store.
4
Store the station.
Press the ENTER button on the wireless remote. A preset location
will show and begin to flash. The station stored in that preset will be
displayed in the lower right-hand corner of the LCD display.
Use the VOLUME + and – VOLUME buttons on the wireless remote
to select the preset location you want to store the station in.
Press the ENTER button to store the station in the preset location.
You can store one FM station in each preset location.
5
To store other preset stations, repeat the above steps.
How to Recall Preset Stations
1
Ensure your speaker system is powered on.
2
Make sure you are in "FM" mode.
3
Use the and buttons on the wireless remote to select
the desired preset.
The radio will tune to your preset station.
4
Adjust the volume.