Panasonic HX-DC3 Owner's Manual page 152

When you use the unit in a sandy or dusty place such as a beach,
do not let sand or fine dust get into the body and terminals of the
unit.
Also, keep the unit away from sea water.
≥ Sand or dust may damage the unit. (Care should be taken when
inserting and removing a card.)
≥ If sea water splashes onto the unit, wipe off the water with a well wrung
cloth. Then wipe the unit again with a dry cloth.
When carrying the unit, do not drop or bump it.
≥ A strong impact can break the unit's casing, causing it to malfunction.
Cleaning
≥ Before cleaning, detach the battery or pull the AC adaptor from the AC
outlet, and then wipe the unit with a soft, dry cloth.
≥ If the unit is very dirty, dip a cloth in water and squeeze firmly, and then
wipe the unit with the damp cloth. Next, dry the unit with a dry cloth.
≥ Use of benzine, paint thinner, alcohol, or dishwashing liquid may alter
the camera body or peel the surface finish. Do not use these solvents.
≥ When using a chemical dust cloth, follow the instructions that came
with the cloth.
Do not use the unit for surveillance purposes or other business
uses.
≥ This unit was designed for consumer intermittent use. It was not
intended for continuous use, or for any industrial or commercial
application resulting in prolonged use.
≥ In certain situations, continuous use could cause the unit to overheat
and cause a malfunction. Such use is strongly discouraged.
When you are not going to use the unit for an extended time
≥ When storing the unit in a cupboard, it is recommended that you place
a desiccant (silica gel) in with it.
When disposing of or giving away this unit, note that:
≥ Conducting a logical format or deleting the data on the built-in memory
of this unit only modifies the file management records, and the data
contained within the built-in memory is not completely deleted. The
data may be able to be recovered using commercially available
products such as data recovery (restoration) software.
≥ When disposing of/giving away the unit, we recommend that you
physically format the built-in memory of the unit. (l 48)
- 152 -