Table of Contents
Advertisement
FACTORY PRESETS
The following table shows the default factory settings:
Display
LANGUAGE .............................................................................. English
STUTTER TONE .............................................................................. No
AREA CODE ....................................................................... No Setting
LDS CODE ........................................................................................ 1
TIME & DATE ...................................................................... No Setting
FLASH TIMER .......................................................................... 600 ms
RINGER CADENCE .......................................................................... 3
RINGER VOLUME ............................................................................. 5
VOICEMAIL NUMBER ......................................................... No Setting
#3 SEC PAUSES ................................................................ No Setting
VM PASSWORD .................................................................. No Setting
HOLD MODE ............................................................................ Normal
RELEASE MODE .................................................................. New Call
Note: After the unit has been completely configured for the first time, use MENU
to review or reprogram the features.
After the adapter is connected, the display will show as indicated below for setting.
1.
[SELECT LANGUAGE] appears on the display. Press REVIEW UP to select
the language. ENG - English, ESP - Spanish, FRE - French, and then press
MENU to confirm the selection.
2.
When [ENTER AREA CODE] appears, enter the desired area code using
the keypad. Use REVIEW UP and REVIEW DOWN to skip a digit. Press
MENU to confirm area code. Follow the same procedure for both area code
settings. To leave an area code blank, press MENU without entering digits.
3.
When [SET LDS CODE] appears, enter the desired LDS code using the
keypad. Press MENU to confirm the selection.
4.
When [EDIT TIME & DATE] appears, enter the time using the keypad.
Press REVIEW UP and REVIEW DOWN to select AM or PM. Enter the date
using the keypad. Press MENU to confirm the settings.
Example: To enter 8:35 AM, enter 0835 and then press REVIEW UP to skip
to the date because the time is AM by default.
5.
When [FLASH TIMER (MS)] appears, press REVIEW UP to toggle between
600ms, 100 ms, and 300ms. After selecting the desired flash time, press
MENU to confirm selection.
U
S
NIT
ETUP
11
Setting
Advertisement
Table of Contents
