Changing The Tv's Input - Emerson Hello Kitty HKTV13 Owner's Manual

Changing the TV's Input

Normally, your TV displays the signal coming through the antenna terminal. However, If you've
connected another component to your TV(such as a VCR) using the Video/Audio input, you will
want to be able to view the signal from the component.
To do this, you will need to switch from the 'TV' input to the ' Line ' Input.
Simply press "INPUT" button on remote control. Or follow steps as below.
1 On "MENU" mode, select "SETUP" and enter "Set-Up" menu.
2 Use the VCHW buttons to select " Input ".
3 Press the CVOLB buttons to change from 'TV' to ' Line '.
4 Wait 10 seconds, or press the MENU button to return to normal TV viewing.
1
Set-Up
Language :
Reception :
Memorize Channels
Add/Delete Channels
Input :
Select Adjust
If two separate AV components are connected at front and rear VIDEO IN/AUDIO IN jacks, the
"SOURCE" from front inputs takes priority. To operate through rear input, make sure to disconnect
front inputs.
14 Chapter 3 : Operating Your TV
2
Set-Up
English Language :
Air
Reception :
Memorize Channels
Add/Delete Channels
TV
Input :
Next Select
3
Set-Up
English
Language :
Air Input :
TV
Adjust Next
Select
English
Line
Adjust Next