How To Initialize The Tv/Dvd - Emerson EWC09D5B Service Manual

HOW TO INITIALIZE THE TV/DVD

To put the program back at the factory-default, initialize the TV/DVD as the following procedure.
< DVD Section >
1. Press [1], [2], [3], [4], and [DISPLAY] buttons on the
remote control unit in that order.
Fig. g appears on the screen.
" ******* " differ depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : CLEAR
Fig. g
2. Press [CLEAR] button on the remote control unit.
Fig. h appears on the screen.
" ******* " differ depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : OK
EEPROM CLEAR : CLEAR
Fig. h
When "OK" appears on the screen, the factory
default will be set. Then the firmware renewal
mode is complete.
3. To exit this mode, press [CH o / p] or [SELECT]
button to go to TV mode, or press [POWER] button
to turn the power off.
EXIT: SELECT
EXIT: SELECT
1-7-1
< TV Section >
1. Use the service remote control unit.
2. Turn the power on. (Use main power on the TV
unit.)
3. Press [DISC MENU] button on the service remote
control unit to enter the Service mode. (Refer to
"How to Set up the Service mode" on page 1-6-1.)
4. Press [VOL p] button on the service remote
control unit twice, and confirm that OSD indication
is "7F = FF." If needed, set it to become "7F = FF"
by pressing [CH o / p] buttons on the service
remote control unit.
5. Confirm that OSD indication on the four corners
on TV screen changes from on and off light
indication to red by pressing a [DISPLAY] button.
(It takes one or two seconds.)
6. Turn the power off by pressing main power button
on the TV unit, and unplug the AC cord from the
AC outlet.
TD300INT