Table of Contents
Advertisement
OPERATING INSTRUCTIONS (continued)
SETUP MENU
MENU
Selected characters
System
Colour System
AV1
AV2
AV3
AV4
Video Input
AV1
AV2 (1st step)
AV2 (2nd step)
AV4
38
Picture
Audio
Timer
Function
Setup
Language
Select
OK Set
System1
System2
System 1
Auto
PAL
SECAM
NTSC3.58
NTSC4.43
System 2
Auto
NTSC-M
PAL-N
PAL-M
Auto
HDTV
SDTV/DVD
RGB
Composite/Component
Auto
HDTV
SDTV/DVD
S.Video
Composite
Setup
System
System 1
OK
Colour System
Video Input
Audio Input
Scart Output
Monitor
RGB1
DVI-STB
RGB2
Component
HDTV
Select
OK
Set
Return
Setup
System
System 1
Colour System
Video Input
Audio Input
Scart Output
Monitor
RGB1
DVI-STB
RGB2
Component
HDTV
Select
OK
Set
Return
Setup
System
System 1
Colour System
Video Input
Audio Input
Scart Output
Monitor
RGB1
DVI-STB
RGB2
Component
HDTV
Select
Set
Return
OK
System1 : Europe/Asia, System2 : North America
This should correspond to the colour system of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The system of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
• When the component signal is received, this would be not available
(grayed out).
(Same to AV1)
This should correspond to the signal mode of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
This should correspond to the signal mode of the signal from the
equipment that is connected to AV2 video input terminal.
This step should be set only when [Composite/Component] is selected on
the 1st step. And the procedure is same to AV1.
• If the signal from the equipment that is connected to AV4 Scart input
terminal is S.Video or Composite, set this to correspond to that signal.
• If the signal is RGB, it will be automatically recognized and this setting
will have no effect.
Setup
Colour System
OK
AV1
Auto
AV2
PAL
AV3
SECAM
AV4
PAL
Select
Return
Exit
Setup
Video Input
OK
AV1
Auto
AV2
Composite/Component
AV3
Auto
AV4
S.Video
Select
Return
Exit
Setup
Audio Input
OK
AV1
Stereo
AV2
L/Mono
AV3
Stereo
AV4
L/Mono
Select
Return
Exit
Setup hint
Advertisement
Table of Contents
