Network Menu - Hitachi CP-X10000 User Manual

NETWORK menu

NETWORK menu NETWORK menu
Remember that incorrect network settings on this
projector may cause trouble on the network. Be sure
to consult with your network administrator before
connecting to an existing access point on your
network.
Select "NETWORK" from the main menu to access
the following functions.
Select an item using the
and press the
button on the remote control to execute the item. Then perform it according to the
following table.
See the User's Manual - Network Guide for details of NETWORK operation.
NOTE • If you are not utilizing SNTP (
Manual - Network Guide), then you must set the DATE AND TIME during the
initial installation.
Item
SETUP
(continued on next page)
56
/ cursor buttons on the projector or remote control,
cursor button on the projector or remote control, or ENTER
Selecting this item displays the SETUP
Menu for the network.
Use the / buttons to select an item,
and the or ENTER ENTER button on the remote
control to perform the item.
Use the
ON
Select OFF when the network does
DHCP
(Dynamic
not have DHCP enabled.
Host
• When the "DHCP" setting changes to "ON", it takes a
Confi guration
little time to obtain IP address from DHCP server.
Protocol)
• Auto IP function will be assigned an IP address if the
projector could not obtain an IP address from server
even if DHCP is "ON".
Date/Time Settings of the User's
Description
/ buttons to turn DHCP on/off.
OFF
ENTER