Epson WorkForce AL-M400DN User Manual page 104

AL-M300/AL-M400 Series User's Guide
The printer cannot store the data of your print job using the Reserve Job function. The maximum
number of print jobs stored on the printer's memory has been reached, or the memory has no more
memory available to store a new job. To store a new print job, delete a previously stored job. Also, if
you have any Confidential Jobs stored, printing those jobs will make more memory available.
You may also increase the available memory space by changing the RAM Disk setting to Normal or
Maximum. For details, see "Setup Menu" on page 69.
To clear this warning message, select Clear Warning from the control panel's Reset Menu. For
instruction about accessing the control panel menus, see "How to access the control panel menus" on
page 60.
Reset All
All printer's interface has been reset and the buffer has been cleared. The printer reboots
automatically.
Reset to Save
A control panel menu setting was changed while the printer was printing. Press the OK button to clear
this message. The setting will become effective after printing has finished.
Alternatively you can clear this message by performing Reset All on the control panel. However, the
print data will be deleted.
ROM CHECK
The printer is checking the ROM.
SELF TEST
The printer is currently performing a self test and initialization.
Service Req Cffff/ Service Req Exxx
A controller error or a print engine error has been detected. Turn off the printer. Wait at least 5
seconds, then turn it back on. If the error message still appears, write down the error number listed on
the LCD panel (Cffff/Exxx), turn off the printer, unplug the power cord, then contact a qualified
service representative.
Shake and reinstall Photoconductor
Using the Control Panel 104