Canon HV30E Instruction Manual page 29

6
Press .
FUNC.
appears. Note that if the joystick
guide appears on the screen, it will
conceal the icon. Press (
hide the joystick guide.
* In mode, select [
OUT SETUP] instead.
T
O ADJUST THE VOLUME OF THE HEADPHONES
In mode, adjust the volume of
the headphones with the [PHONES VOL.]
setting ( 39). In
the joystick and the joystick guide
following the same procedure as when
adjusting the speaker's volume.
IMPORTANT
Do not connect the headphones to the AV/
terminal if the icon does not appear on the
screen. If you connect the headphones while
the terminal is set to AV output only noise will
be output.
When using headphones, make sure to lower
the volume to an appropriate level.
The sound of the built-in speaker will be
muted when you close the LCD panel, when
you connect the stereo video cable to the
AV/ terminal or when the AV/
set to [ PHONES].
NOTES
Use commercially available headphones with
a ∅ 3.5 mm minijack and a cable no longer than
3 m.
When you turn off the camcorder, the
[AV/PHONES] setting in
return to [ AV].
The volume of the headphones cannot be
adjusted while recording.
Returning to a Pre-marked Position
If you wish to return to a particular scene
) to
later, mark the point with the zero set
memory and the tape will stop at that
PLAY/
point when you rewind/fast forward the
tape.
1
While recording or during playback,
mode, use
press
wireless controller at the point you
wish to return to later.
• The time code changes to
"0:00:00
• Press
cancel the memory.
2
If you marked the zero memory
while recording, set the camcorder
to
the zero memory during playback,
press
3
Press
• If the tape counter shows a negative
number, press
•
rewinds/fast forwards the tape.
• The tape stops at or near the zero
mark,
time code will be displayed again.
terminal is
If there are blank sections between recordings
or sections recorded in different standards
(HDV/DV) on the same tape, the zero set
memory may not work correctly.
mode will
ZERO SET MEMORY
".
ZERO SET MEMORY
mode. If you marked
.
to locate the zero mark.
instead.
appears and the camcorder
disappears and the correct
NOTES
Playback 29
( 8)
on the
again to