Emerson Research SmartSet CKS3516 Owner's Manual page 16

Wake To BUZZER (Crescendo Alarm)
NOTE: Alarm 1 and Alarm 2 have different buzzer sounds.
• Alarm 1 is a "Single beep" sound.
• Alarm 2 is a "Double beep" sound.
You will be able to tell which alarm is going off by the sound that it makes.
1.) Reconfirm the wake up time and alarm mode settings for the alarm you are
using, Alarm 1, Alarm 2, or both alarms.
2.) Set the ALARM selector switch for one or both alarms to the BUZZER position.
The appropriate AL 1 and/or AL 2 indicators will light up to confirm that the
alarms are set.
3.) At the selected wake up time the buzzer will sound. It will begin softly and
gradually increase in volume to wake you up. It will continue for one hour and
then shut off automatically.
4.) To stop the buzzer sooner, press either the appropriate ALARM 1 or ALARM 2
button. The buzzer will stop but the alarm remains set and will turn the buzzer
on again at the same time on the following day (depending on the Alarm Mode
setting).
To stop the buzzer and turn on the radio immediately, press the RADIO ON/
OFF button instead of the ALARM 1 or ALARM 2 button.
5.) If you do not want the alarm to turn the buzzer on the following day, set the
appropriate ALARM selector to the "OFF" position.
Radio And Buzzer Operation
You may also set one alarm for wake to RADIO and the
other for wake to BUZZER. Just set the ALARM 1 and
ALARM 2 selector switches to the desired positions.
CKS3516-26_070307.p65
15
15 3/7/2007, 17:09