Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Emerson Research SmartSet CKS3516
Summary of Contents for Emerson Research SmartSet CKS3516
-
Page 1: Clock Radio
SmartSet with Auto-Time Setting System, Jumbo Display, Dual Alarms, Sure Alarm, and Time Projection System (U.S. Patent No. 6,567,344) OWNER’ S MANUAL CKS3516 CKS3526 Visit our web site at www.emersonradio.com CKS3516-26_070307.p65 ® Clock Radio 3/7/2007, 17:09... -
Page 2: Important Safety Instructions
15.) The product may be mounted to a wall only if recommended by the manufacturer. 16.) Upon completion of any service or repairs to this product, ask the service technician to perform safety checks. CKS3516-26_070307.p65 CAUT I ON C AU T I O N... - Page 3 There is a long life lithium battery installed in this clock radio when you buy it. This battery can maintain the time and alarm settings for 3 to 5 years, or even longer, so there is no need to pay for a new 9-volt battery every 6 months, as is recommended in other clock radios with normal battery back up.
-
Page 4: Fcc Information
Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment. CKS3516-26_070307.p65 • Operate controls and switches as described in the manual. • Before turning on the power, make certain that the AC power cord is properly installed. - Page 5 'feet' before you place the product on fine wooden furniture. CKS3516-26_070307.p65 3/7/2007, 17:09...
-
Page 6: Power Source
This SmartSet ® Clock Radio includes a Sure Alarm battery back-up circuit that can wake you up even if the power is ‘ Off’ at the selected wake up time. If your power is ‘ Off’ at the selected wake up time the clock display will be off and the radio will not operate, but a separate mini-buzzer will turn ‘... - Page 7 L O C AT I O N O F C O N T R O L S AN D I N D I C AT O R S Front Panel Top Panel Left Side Panel CKS3516-26_070307.p65 Right Side Panel 3/7/2007, 17:09...
- Page 8 26.) SET + Button. 27.) RADIO ON/OFF Button. 28.) SNOOZE/SLEEP OFF Button. 29.) ALARM 1 (RADIO/BUZZER/OFF) Selector Switch. 30.) ALARM 2 (RADIO/BUZZER/OFF) Selector Switch. 31.) Display DIMMER (HI/LO) Selector Switch. 32.) Back Up Battery Compartment (Bottom Cabinet). CKS3516-26_070307.p65 3/7/2007, 17:09...
- Page 9 If you move to a different time zone, simply change the default zone display to the ® new zone and the SmartSet CKS3516-26_070307.p65 ® clock radio as follows: — Atlantic Time —...
-
Page 10: Date Display
• End of Daylight Saving Time: At “3:00 AM” on the 1st Sunday in November, the clock will automatically reset to “2:00 AM”. • Leap Year: At “12:00 Midnight” on February 28th, the calendar display will change to “2.29”. CKS3516-26_070307.p65 3/7/2007, 17:09... -
Page 11: Manual Time Adjustments
NOTE: If you manually adjust the time, your new setting is entered into the SmartSet ® memory. If the power is interrupted, the display will return to your new setting, not the original setting, when the power is restored. CKS3516-26_070307.p65 3/7/2007, 17:09... -
Page 12: Adjusting The Wake Up Times
® Your SmartSet clock radio has two separate alarms that can be set and used independently. You may use the alarms to wake two people at different times, or you may use one alarm for weekdays and the other for weekend wake up times. -
Page 13: Selecting The Alarm Mode
Selecting The Alarm Mode ® Your SmartSet clock radio allows you to select from among three different alarm operation modes for either alarm. The alarm modes are: • Everyday – the alarm will turn on all 7 days. • Weekdays only – the alarm will only turn on Monday through Friday;... -
Page 14: Listening To The Radio
– The FM antenna is built in to the AC power cord. If FM reception is weak try varying the position and direction of the AC power cord until you find the strongest signal. CKS3516-26_070307.p65 3/7/2007, 17:09... -
Page 15: Wake To Radio
(depending on the Alarm Mode setting). 6.) If you do not want the alarm to turn the radio on the following day, set the appropriate ALARM selector switch to the “OFF” position. CKS3516-26_070307.p65 3/7/2007, 17:09... - Page 16 ALARM selector to the “OFF” position. Radio And Buzzer Operation You may also set one alarm for wake to RADIO and the other for wake to BUZZER. Just set the ALARM 1 and ALARM 2 selector switches to the desired positions. CKS3516-26_070307.p65 3/7/2007, 17:09...
- Page 17 The corresponding AL indicator will flash. The alarm will stop for approximately 9 minutes and then comes ‘ On’ again. The Snooze operation maybe repeated several times if desired but after one hour the alarm will not come on again. CKS3516-26_070307.p65 3/7/2007, 17:09...
-
Page 18: Dimmer Control
DIMMER Control The DIMMER control was set to the HI (High) position at our factory. If you find the clock display is too bright in a darkened room, set the Dimmer control to the LO (Low) position. CKS3516-26_070307.p65 3/7/2007, 17:09... -
Page 19: Important Notes
1.) Switch off the room lights to darken the room. 2.) Press the PROJECTOR ON/OFF button to turn the projector ‘ On’ . 3.) Turn the projector unit slowly to aim the projected image on the wall or ceiling. CKS3516-26_070307.p65 PROJECTOR ON/OFF Button 3/7/2007, 17:09... - Page 20 5.) If the image appears ‘ fuzzy’ and out of focus, slowly rotate the focus adjustment ring clockwise or counter-clockwise until you obtain the sharpest image. 6.) If you no longer wish to see the projected image, press the PROJECTOR ON/ OFF button to turn the projector ‘ Off’ . CKS3516-26_070307.p65 3/7/2007, 17:09...
-
Page 21: Changing The Lithium Battery
3.) Turn the radio face up and use a small screw driver to remove the screw securing the battery holder to the cabinet. BE CAREFUL NOT TO LOSE THIS SMALL SCREW! CKS3516-26_070307.p65 ® computer memory. Once you plug the radio in, ®... - Page 22 5.) Replace the screw that secures the battery holder in the cabinet. 6.) Turn the radio right side up and confirm that the ‘ Off’ . 7.) Save these instructions. You’ ll have to do this again five to eight years from now! CKS3516-26_070307.p65 LOW BATT. . indicator is 3/7/2007, 17:09...
-
Page 23: Resetting The Clock After A Total Memory Loss
‘ Time’ to ‘ Year’ . While holding the MONTH/DATE and TIME buttons, press the SET + button to set the display to the correct year, then release the buttons. CKS3516-26_070307.p65 ® memory will be lost and the clock ®... -
Page 24: Important Note
5 to 8 years, depending on the number and duration of the power outages you experience. IMPORTANT NOTE: After resetting the clock, don’ t forget to reset your wake up times, and alarm mode settings, and sleep timer settings as well. CKS3516-26_070307.p65 3/7/2007, 17:09... -
Page 25: Care And Maintenance
FOR CUSTOMER SERVICE,PLEASE WRITE TO: CKS3516-26_070307.p65 TO FIND THE LOCATION AND PHONE NUMBER OF YOUR NEAREST SERVICE CENTER PERMITTED TO PERFORM WARRANTY... 1-800-695-0098 PLEASE CALL: 1-800-898-9020 Emerson Radio Corp., Consumer Affairs Dept., 5101 Statesman Drive, Irving, TX 75063. 3/7/2007, 17:09... -
Page 26: Limited Warranty
Emerson Radio Corp. in the amount of $9.00 (not required by California residents) to cover shipping and handling costs, and enclose a copy of your proof of purchase. - Page 27 EMERSON Part No. 16-3004 Printed in China 705-05 CKS3516-26_070307.p65 3/7/2007, 17:09...
Need help?
Do you have a question about the SmartSet CKS3516 and is the answer not in the manual?
Questions and answers
how to switch off the alarm
To switch off the alarm on the Emerson SmartSet CKS3516, set the ALARM 1 and/or ALARM 2 switches to the "OFF" position. This will disable the alarm.
This answer is automatically generated
How do you turn off the alarm settings. We do not want any alarms to sound.
To turn off the alarm settings on the Emerson SmartSet CKS3516, set the appropriate ALARM selector (ALARM 1 or ALARM 2) to the “OFF” position. This prevents the alarm from sounding the following day.
This answer is automatically generated
how to completely turn off the alarms on model CKS3516. Do not need to sue them.
To completely turn off the alarms on the Emerson Research SmartSet CKS3516, locate the AL 1 (Alarm 1 ‘On’) Indicator and AL 2 (Alarm 2 ‘On’) Indicator on the front panel. Use the alarm control buttons to deactivate both alarms. Ensure that neither alarm indicator is displayed on the screen, confirming that both alarms are turned off.
This answer is automatically generated
apres une panne d'électricité mon projecteur ne fonctionne plus, meme en pesant sur le bouton pour le rallumer, y a t-il une lumiere a changer?
The manual does not mention the need to replace a projector light after a power outage. However, it does describe a Sure Alarm battery backup system that ensures the alarm works even if the power is off. If the projector does not turn on after a power outage, checking the power connection, the projector ON/OFF button, and the lithium battery status may help resolve the issue.
This answer is automatically generated
is there a way to brighten the projected time? cannot see it very well anymore
The projected time on the Emerson Research SmartSet CKS3516 is only visible when the room is dark. To make it appear brighter, turn off the room lights. Additionally, ensure that the time projector is turned on by pressing the PROJECTOR ON/OFF button.
This answer is automatically generated
What can I do to repair my projector?