Hot Water Supply; Water Line Connection - GE CDWT9 - Cafe 24 in. Dishwasher Installation Instructions Manual

Installation Preparation-Hot Water Supplg
PREPARE HOT WATER SUPPLY
Hot Water Line
• The line may enter from either side, rear or floor within the
shaded area shown in Figure F.
• The line may pass through the same hole as the electrical
cable and drain hose, or an additional 1-1/2" diameter hole
may be cut to accommodate the water line. If a power cord
with plug is used, the water line must not pass through the
power cord hole.
/ I I x
/ \
/ I I \
I I \
I I \
/
CAUTION
The hot water supply line pressure must be at least 20 PSI.
Lower pressures could cause the water valve to leek and
cause water damage.
_4L PRECAUCION
La linea de presi6n del suministro de agua caliente debe
ser al menos 20 PSI. Presiones inferiores podrian causar
que la v61vula del agua gotee g causar da5os por agua.
il Shut-off 7
Hot
From
Cabinet
Cabinet
Figure F
2" From Floor
Water Line Connection
• Turn off the water supply.
• Install a hand shut-off valve in an accessible location, such
as under the sink. (Optional, but strongly recommended
and may be required by local codes.)
• The water connection is on the bottom-left side of the
dishwasher. Install the hot water inlet line, using 3/8"
or larger copper tubing. Route the line as shown in Figure F
and extend forward at least 19" from rear wall.
• Adjust the water heater to deliver water between 120°F
and 150°F.
• Flush water line to clean out debris. Use a bucket to catch
water and debris.
• The hot water supply line pressure must be between 20
and 120 PSI.