Intellimute Pro - Cobra 15 BAND XRS 9770 Operating Instructions Manual

Settings
Your Detector
Program/Mute Button
To Set the IntelliMute Activation Point Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to Set IntelliMute.
Press and release the Set/City button to
begin setting IntelliMute RPMs.
Rev your engine to the level you wish to
set. Rev the engine slightly above idle and
hold revs steady for two seconds.
At the desired rev level, press and
release the Set/City button.
Press and release either the Select/Dim
button to proceed to the next user mode
or the Program/Mute button to exit the
Program mode.
NOTE
If the unit is unable to sense usable pulses within
three seconds or if you do not set a rev point within
20 seconds of beginning these steps, IntelliMute will
indicate an error and automatically turn Off.
Tone Visual Display Voice
IntelliMute not set IntelliMute not set
One beep
Please try again Please try again
One beep IntelliMute Off IntelliMute Off
16 English
Set/City
Button
Select/Dim
Button
Tone
Visual Display Voice
None Set IntelliMute None
Press SET Set Engine
Two beeps
at desired
Revs
RPMs...
None None None
Three beeps IntelliMute IntelliMute
Set! Set
None None None
Setting IntelliMute RRMs
Se t I n te l. . . P r essS E T . .. In telli
Mu te
S et!
IntelliMute Off
IntelliMute
Not Set
In telli
In telliMu .. .
Mu te
P lease tr .. .
O ff
Settings
Your Detector

IntelliMute Pro

IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as
VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is intended for
use by experienced users only.
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
activation point, your detector's radar detection circuits are turned Off to prevent
detection by RDDs.
Before IntelliMute Pro can be turned On, you must have turned On and Set
the IntelliMute activation point. (See pages 14 through 16.)
CAUTION
When IntelliMute Pro is On, NO radar signals will be detected and
NO alerts will be given at RPMs below the IntelliMute activation point.
To Turn IntelliMute Pro On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
Tone
go to IntelliMute Pro.
Two beeps
One beep
IntelliMute Pro On
Intelli
Mute Pro
On
N W
Visual Display Voice
IntelliMute Pro On, IntelliMute Pro On
then i blinks
in the display
IntelliMute Pro Off, IntelliMute Pro Off
then i is
steady in the
display
IntelliMute Pro Off
Intelli
Mute Pro
Off
i h N W i h
Nothing Comes Close to a Cobra 17
®