Hitachi HIT15WDVB Instruction Manual page 15

Connecting a TV Cable or an Antenna
Refer to the owner's manual of the external equipment to be connected. When connecting external
equipment, do not connect any AC power cords to wall outlets until you have completed all the
connections.
Basic Connection: Connecting an aerial
Unplug from a
wall outlet
Connect your existing TV aerial to the Aerial input socket on the TV.
The Aerial input socket can be connected with the ATV / DTV Aerial.
Insert the supplied mains cable to the mains socket located on the rear of the TV.
Connect the other end of this cable to a 3-pin mains socket.
Connect all AC power sources before turning on the power switch at the back of the TV.
Press the STANDBY
a. After connecting an aerial to your LCD TV and connecting the mains cable to the
TV and mains socket, turn the POWER SWITCH of rear TV on, a red light will show
on the front panel of the TV.
b. Press the STANDBY
Installation screen will show:
1. Make sure an aerial is fitted then press OK button on the remote to start the Auto
Programme Scan ( APS ).
2. In a short while you will see the TV programmes briefly as each channel is received and
stored in the memory. When APS is completed, BBC1 will show, press CH.
to view the other channels stored.
c. To power off press the STANDBY
5
Press the INPUT button and choose TV or DTV mode then press OK to select.
If you encounter problems receiving digital signals this may be due to having an inadequate aerial (you may
have an old "Analogue" aerial). A replacement "Digital" aerial will be required, contact your local aerial
installer for further information.
14
Make sure the power switch
is switched off
Connects the supplied
mains cable to this socket.
button on your remote to turn on your LCD TV.
button, the red light will change to green and the First Time
button, the green light will change to red.
VHF/UHF IN
AC IN 100-240V AC POWER
50/60Hz SWITCH
PC AUDIO IN
TV Aerial
Aerial/75-ohm coaxial input
buttons