Lightolier TRACK COUPLE Instructions For Maintenance Reference

.
\
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE INSTRUCTION SHEET NO.
"his fixture is intended for installation in accordance with the National Electrical Code and local regulations.
"o assure full compliance with local codes and regulations, check with your local electrical inspector before
IS:9149
wtallation. Toprevent electrical shock, turnoff electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
0395 Page 1 of 1
TRACKCOUPLER
FOR USE WITH PROFILE TRACK SYSTEMS ONLY
WARNING:
TURN OFF POWER AT ELECTRICAL PANEL BEFORE INSTALLING ELECTRICAL CONNECTOR AND TRACK.
DO NOT ATTEMPT TO FEED POWER TO THE TRACK COUPLER.
A.
INSTALLING TRACK COUPLER
1.
Remove DEAD ENDS from track SECTIONS. SAVE THE DEAD ENDS.
2. Point the POLARITY TAB away from the BEAD on the track.
3. Push TRACK COUPLER into both track units, Ensure CONTRACT
BLADES insert into the TRACK CONDUCTOR GAPS.
4. Tighten LOCKING SCREW.
5. Install track per Instruction Sheet 9100 which is included with the
track units.
LOCKING SCREiV—
i
r
BEAD
4
TRACK BEAD
I
/
;/,-
- /
_.
— —-
/-. .
,&L –_: -—
—t
"-: -~~z-.?
e
—:i ' ~
'e w,
':i,r_.. —–
—— ~A... . . .. .. —––-———
\ ---
\
--y
-\J2
-. -—-d
\L ~ '—-—-
)
'—
POLARITYTAB
— POLARITYTAB
TRACK UNIT
i
/
r
TRACK COPPER
CONOUCTOR
-CONTACT BLAOE
>~~~<sp
L
4
~Q&=-~
~! ,
OEAO ENO -
lmlc31+Tc>l.llm
o
FALL RIVER, MASSACHUSETTS, 02720
MONTREAL, QUEBEC, CANADA
#