Setting Up Static Multicast Groups - NETGEAR GS748TS-100NAS User Manual

2. Select Enable or Disable
3. Click Apply to save your settings.

Setting Up Static Multicast Groups

You can specify specific ports and VLANs for receiving Multicast packets with specific MAC
addresses. The MAC addresses are IPv4 Multicast Addresses (RFC1112A) of the form: 01:00:5E-
XX-XX-XX. A maximum of 64 groups is supported.
To define a multicast group:
1. From the main Navigation Pane menu, select:
→
Switch Multicast
displayed as shown below.
Figure 4-17
2. In the appropriate windows, enter the VLAN ID and Port to receive the Multicast packets
3. In the MAC Address window, specify the Multicast MAC Address for the packets you want
to receive.
4. Click Apply to save your settings.
To remove a multicast group:
1. In the line of the table that specifies the group, check the Delete box.
2. Click Apply to remove the group.
Configuring the Switch
→
Static Multicast Group; the Static Multicast Groups Setting page is
v2.0, April 2007
GS748T Software User Manual
4-21