Table of Contents
Advertisement
•
Speed: Indicates the communication mode set for the port. The default setting for all ports
is Auto-negotiation (Auto). The possible entries are:
•
Auto: Auto-negotiation
•
100M Full: 100 Mbps full duplex
•
100M Half: 100 Mbps half duplex
•
10M Full: 10 Mbps full duplex
•
10M Half: 10 Mbps half duplex
•
Disable
•
Flow Control: may be set
•
Default Priority: This value indicates the default traffic priority f or the port in the
implementation of Port-based Quality of Service (QoS). The values may be set to 0 - 7.
Note: In order for it to work, you must map the priority to the appropriate 4
To activate the new settings, click Apply.
Note: Speed must be set to the same value as for the port's link partner. If this is not done,
packet loss or link errors may occur.
Viewing Packet Statistics
This page shows reports of packet traffic and packet errors. The table headings meanings are
explained as follows:
•
ID: The port number on the switch
•
Tx: Transmitted packets
•
Rx: Received packets
•
Tx Error: Transmitted packets with error. Packets are counted as contributing to TX Error if
they:
•
Had a late collision detected during the transmission (512 bit-times into the transmission)
•
Experienced 16 failed transmission attempts due to collision.
•
Were dropped due to lack of resources
Configuring the Switch
on
for Flow Control support or
queues in the IEEE802.1P of Switch > QoS page.
v2.0, April 2007
GS748T Software User Manual
off
for no flow control.
4-3
Advertisement
Table of Contents
