Modifying The Route; Selecting A New Destination When A Route Is Already Set; Setting A New Starting Position For The Route - Pioneer AVIC-U250 Owner's Manual

Chapter
08 Checking and modifying the current route
p Carpool or HOV lanes can be used if a
given number of passengers are travel-
ing in the vehicle.
! Unpaved Roads:
Set whether to include unpaved roads. The
navigation system excludes unpaved roads
by default.
! Calculate Green Alternative:
If the selected routing method is not
"Green", you can have your route compared
to the best green alternative on the screen
when confirming the route. If this alterna-
tive is much better than the selected meth-
od, you can quickly switch to "Green"
mode.
5 Touch [Back] to confirm the changes.
The navigation system recalculates the route.
The orange line now shows the new recom-
mended route.

Modifying the route

When navigation is already started, there are
several ways to modify the current route. The
following sections describe some of those op-
tions.
Selecting a new destination
when a route is already set
If you already have a recommended route and
you select a new destination, the navigation
system will ask you whether to start a new
route, add a new waypoint to the route or ap-
pend the newly selected destination at the end
of the current route.
! New Route:
46
En
Touch this key to plan a new route to the
newly selected location. The previous desti-
nation and waypoint(s) are deleted.
! Waypoint:
Touch this key to add the newly selected lo-
cation as a waypoint to your route. The
other destinations of the route remain in-
tact.
p The new waypoint is placed among des-
tinations to keep the route optimal. To
decide where a waypoint to appear, use
the "Edit Route" menu.
! Final Destination:
Touch this key to append the newly se-
lected destination at the end of the route.
The other destinations of the route remain
intact. The previous final destination is now
the last waypoint.
Setting a new starting position
for the route
For normal navigation, all routes are planned
from the current position. In order to check fu-
ture routes, simulate them or see their length
in time and distance, you can turn off the GPS
receiver. Then you can set the starting point of
the route to a different location than the cur-
rent GPS position.
1 Touch [Menu] on the map screen.
The "Navigation Menu" screen appears.
= For details of the operations, refer to Screen
switching overview on page 19.
Touch [My Route] on the "Navigation
2
Menu" screen.