Miscellaneous; Hardware Setup - Onkyo TX-NR727 Owner's Manual

6. Miscellaneous

Volume Setup
■
Volume Display
Absolute:
Displayed range is Min, 1 to 99, Max.
Relative (THX):
Displayed range is – dB, –81dB to +18dB.
With this setting, you can choose how the volume level
is displayed.
The absolute value 82 is equivalent to the relative
value 0 dB.
Note
• If the absolute value is set to 82, "82Ref" will appear on the
display and the THX indicator will flash.
■
Muting Level
– dB (fully muted), –50dB to –10dB in 10 dB
steps.
This setting determines how much the output is muted
when the muting function is used (➔ page
■
Maximum Volume
Off, 50 to 99 (Absolute display)
Off, –32dB to +17dB (Relative display)
With this setting, you can limit the maximum volume.
To disable this setting, select "Off".
■
Power On Volume
Last, Min, 1 to 99 or Max (Absolute display)
Last, – dB, –81dB to +18dB (Relative display)
With this preference, you can specify the volume
setting to be used each time the AV receiver is turned
on.
To use the same volume level that was used when
the AV receiver was turned off, select "Last".
The "Power On Volume" setting cannot be set higher
than the "Maximum Volume" setting.
■
Headphone Level
–12dB to 0dB to +12dB
With this setting, you can specify the headphone
volume relative to the main volume. This is useful if
there's a volume difference between your speakers
and your headphones.
OSD Setup
■
On Screen Display
On
Off
This preference determines whether operation details
are displayed on-screen when an AV receiver
function is adjusted.
Even when "On" is selected, operation details may
not be output if the input source is connected to an
HDMI IN.
■
Language
(North American models)
English, Deutsch, Français, Español, Italiano,
50).
Nederlands, Svenska
(European, Australian and Asian models)
English, Deutsch, Français, Español, Italiano,
Nederlands, Svenska, Русский язык,
(Taiwanese models)
English, Deutsch, Français, Español, Italiano,
Nederlands, Svenska,
This setting determines the language used for the on-
screen menus.
■
Screen Saver
3min, 5min, 10min
Off
With this setting, you can set the time until the screen
saver activates itself. Once active, the screen saver
will go off and the screen will return to its previous
state if the AV receiver is operated in any way.
En-69
Advanced Operations

7. Hardware Setup

Tuner
■
AM/FM Frequency Step (North American and
Taiwanese models)
10kHz/200kHz:
9kHz/50kHz:
Select the frequency step according to your
area.
■
AM Frequency Step (European, Australian and
Asian models)
10kHz:
9kHz:
Select the frequency step according to your
area.
For AM/FM tuning to work properly, you must specify
the AM/FM frequency step used in your area.
Note
• When this setting is changed, all radio presets will be
deleted.
HDMI
■
HDMI CEC (RIHD)
Off
On
Turn this setting on to allow
components connected via HDMI to be controlled by
the AV receiver (➔ page 16).
Operating
procedure
(➔ page 56)
-compatible