Remote Control Codes For Onkyo Components Connected Via Ri; Resetting The Remote Mode Buttons; Resetting The Remote Controller; Controlling Other Components - Onkyo TX-NR525 Owner's Manual

Remote Control Codes for Onkyo
Components Connected via RI
Onkyo components that are connected via
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to
control components that are out of view, in a rack, for
example.
1
Make sure the Onkyo component is connected
with an cable and an analog audio cable
(RCA).
See "Connecting Onkyo RI Components" for
details (➔ page 19).
2 Enter the appropriate remote control code for
a REMOTE MODE button, by referring to the
previous section.
42157:
Onkyo cassette tape deck with
81993:
Onkyo Dock with
3
Press the REMOTE MODE button, point the
remote controller at the AV receiver, and
operate the component.
Controlling Onkyo components without
If you want to control an Onkyo component by
pointing the remote controller directly at it, or you
want to control an Onkyo component that's not
connected via , use the following remote control
codes:
30627:
Onkyo DVD player without
71817:
Onkyo CD player without
32900/33100/33500:
Onkyo Blu-ray Disc player
32901/33104/33504:
Onkyo HD DVD player
70868:
Onkyo MD recorder without
are
71323:
Onkyo CD recorder without
82990:
Onkyo Dock without

Resetting the REMOTE MODE Buttons

You can reset a REMOTE MODE button to its default
remote control code.
1 While holding down the REMOTE MODE
button that you want to reset, press and hold
down HOME until the remote indicator lights
(about 3 seconds).
2
Within 30 seconds, press the REMOTE MODE
button again.
The remote indicator flashes twice, indicating that
the button has been reset.
Each REMOTE MODE button is preprogrammed
with a remote control code. When a button is
reset, its preprogrammed code is restored.

Resetting the Remote Controller

You can reset the remote controller to its default
settings.
1 While holding down RECEIVER, press and
hold down HOME until the remote indicator
lights (about 3 seconds).
2 Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that
the remote controller has been reset.
En-58

Controlling Other Components

Controlling Other Components
By pressing the REMOTE MODE button that's been
programmed with the remote control code for your
component, you can control your component as
described below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(➔ page 57).
Controlling a TV
TV is preprogrammed with the remote control code
for controlling a TV that supports the
(limited to some models). The TV must be able to
receive remote control commands via
be connected to the AV receiver via HDMI. If
controlling your TV via doesn't work very
well, program your TV's remote control code into TV
and use the TV remote mode to control your TV.
Use the following remote control codes:
11807/13100/13500:
TV with
Controlling Apple TV
By programming the supplied remote controller with
the appropriate remote control code, you can use it to
operate your Apple TV.
Use the following remote control codes:
02615:
Apple TV
*1
and