Power Requirements; Operating States - Mark Levinson 512 Owner's Manual

Nº512 CD/SACD™ Player
Caution!

Operating States

Caution!

Power Requirements

At the factory, the Nº512 CD/SACD player is configured for 100,
120, 220, or 230–240 VAC power operation at 50Hz or 60Hz. Before
operating the Nº512, ensure that the power label on the rear panel
near the AC input connector indicates the correct operating voltage.
DO NOT attempt to adjust the operating voltage. Consult a Mark
Levinson dealer if the operating voltage is incorrect or must be
changed for relocation purposes.
Different operating voltages may require the use of different
power cords and/or attachment plugs. Contact a Mark Levinson
dealer for additional assistance.
The Nº512 CD/SACD player is designed for continuous operation
and has three operating states:
• Off – when the front panel Power switch is turned off or the
power cord is removed from the rear panel.
• Standby – when the Nº512 is powered up, but the audio
outputs are muted.
• On – when the Nº512 is powered up and fully functional.
BEFORE moving the N
powered off with the Power button. Then make sure the power
cord is disconnected from the rear panel connector and the
electrical outlet.
o
512 CD/SACD player, make sure it is
5