Programme If So Required; Step 7 A Typical Wash Programme - Hotpoint FIRST EDITION WMA11 Instructions For Installation And Use Manual

STEP 7
1
Sort laundry into
groups by washcare
labels.
Load the machine,
making sure that the
laundry is not
trapped in the door.
Close the door by
pushing it until it
clicks.
5
the start of a programme. After a short time
the 'Door Locked' indicator light will
illuminate.
To cancel a programme once the machine
has started, press and hold the 'START/Hold
To Reset' button for two seconds, until the
'Prog End' light flashes.
You can then make a new selection. Press
the 'START/Hold To Reset' button again to
carry on.
WARNINGS:
● DO NOT allow ● DO NOT overload
children to play the appliance!
with the appliance It may damage the
or tamper with the laundry and reduce
controls. the quality of the
wash.
A Typical Wash Programme
2
Add detergent (and
fabric conditioner if
required) to the
dispenser drawer (see
STEP 3).
Refer to the detergent
manufacturer's
dosage instructions.
When all selections
6
have been made press
the 'START/Hold To
Reset' button.
The 'Prog End light
will go out and the
'Active' light will
illuminate to indicate
During the wash, the
'Active' and 'Door
Locked' indicator light
will remain lit.
● During the wash
cycle, remember
that the door glass
may become hot to
the touch.
3 4
Turn the programme Select any optional
selector dial from the wash feature(s) that
'OFF' position to the you may require by
programme required pressing the
(see STEP 4). appropriate button(s)
The 'Prog End' light (see STEP 6) indicator
will illuminate to lights will show what
indicate that the you have chosen.
machine has power.
7
After a short time the 'Door Locked'
indicator light will go out. You can
then open the door.
To switch the machine off, return the
programme selector dial to the 'OFF'
position.
The 'Prog End' light will go out.
We also recommend that you switch
off the electricity and water supply.
● DO NOT open the ● DO NOT try to
dispenser drawer
during any
programme.
When the pro-
gramme has
finished the
'Prog End' and
'Door Locked'
indicator lights
will remain lit.
● If you stop a
open the door programme part
when the 'Door way through a
Locked' indicator wash or there is a
light is on. power cut, take
care when opening
the door, the
machine may
contain hot water.