Table of Contents
Advertisement
Instructions for use
GB
English,1
WMAL 621
WASHING MACHINE
Contents
Installation, 2-3-4-5
Connecting the electricity and water supplies
Wash cycles, 8
Cutting off the water or electricity supply
Troubleshooting, 13-14
Assistance, 15-16
GB
1
Advertisement
Table of Contents
Related Manuals for Hotpoint WMAL 621
Summary of Contents for Hotpoint WMAL 621
-
Page 1: Table Of Contents
Control panel Indicator lights Starting a wash cycle Wash cycles, 8 Table of wash cycles Personalisation, 9 Setting the temperature WMAL 621 Setting the spin speed Functions Detergents and laundry, 10 Detergent dispenser drawer Preparing the laundry Garments requiring special care... -
Page 2: Installation
Installation 2. If the floor is not perfectly level, compensate for any Keep this instruction manual in a safe place for future refe- unevenness by tightening or loosening the adjustable front rence. Should the appliance be sold, transferred or moved, feet (see figure);... -
Page 3: Electric Connection
Connecting the drain hose • the supply voltage is included within the values indica- ted on the Technical Data Plate fixed on the machine. Connect the drain hose, without bending it, to a • the socket is compatible with the washing machine’s draining duct or a wall drain plug. -
Page 4: The First Wash Cycle
As the colours of the wires in the lead may not correspond The first wash cycle with the coloured markings identifying the terminals in your plug, proceed as follows: Once the appliance has been installed, and before you use Connect Green & Yellow wire to terminal marked E or it for the first time, run a wash cycle with detergent and no or coloured Green or Green &... -
Page 5: Technical Data
Technical data Model WMAL 621 width 59.5 cm Dimensions height 85 cm depth 54 cm Capacity from 1 to 6 kg Electrical please refer to the technical data plate fixed to the machine connections maximum pressure 1 MPa (10 bar) Water connections minimum pressure 0.05 MPa (0.5 bar) -
Page 6: Description Of The Washing Machine And Starting A Wash Cycle
Description of the washing machine and starting a wash cycle Control panel WASH CYCLE PROGRESS indicator lights SPIN SPEED knob DOOR ON/OFF button LOCKED TEMPERATURE indicator light knob START/PAUSE button with indicator light FUNCTION Detergent dispenser drawer buttons with indicator lights WASH CYCLE knob Detergent dispenser drawer: used to dispense... -
Page 7: Indicator Lights
Indicator lights Door locked indicator light If this indicator light is on, the appliance door is locked to prevent it from being opened accidentally; to avoid any The indicator lights provide important information. damage, wait for the indicator light to switch off before you This is what they can tell you: open the appliance door. -
Page 8: Wash Cycles
Wash cycles Table of wash cycles Detergents Max. Max. Description of the wash cycle temp. speed (°C) (rpm) Fabric Wash softener CLEAN Plus 1 Anti Stain 180’ 40° 1200 2 Whites 60° 1200 180’ 3 Cottons (4): extremely soiled whites. 90°... -
Page 9: Personalisation
Personalisation Setting the temperature Turn the TEMPERATURE knob to set the wash temperature (see Table of wash cycles). The temperature may be lowered, or even set to a cold wash ( ). The washing machine will automatically prevent you from selecting a temperature which is higher than the maximum value set for each wash cycle. -
Page 10: Detergents And Laundry
Detergent dispenser drawer Garments requiring special care Successful washing results also depend on the correct Wool: The wool wash cycle on this Hotpoint machine has dose of detergent: adding too much detergent will not been tested and approved by The Woolmark Company... -
Page 11: Precautions And Tips
Precautions and tips Consumers should contact their local authority or retailer This washing machine was designed and constructed in for information concerning the correct disposal of their accordance with international safety regulations. The fol- old appliance. lowing information is provided for safety reasons and must therefore be read carefully. -
Page 12: Cutting Off Water And Electricity Supplies
Care and maintenance Cutting off the water and electricity Caring for the door and drum of your supplies appliance • Turn off the water tap after every wash cycle. This will limit • Always leave the porthole door ajar in order to prevent wear on the hydraulic system inside the washing machine unpleasant odours from forming. -
Page 13: Troubleshooting
Troubleshooting Your washing machine could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure that the problem cannot be not solved easily using the following list. Problem: Possible causes / Solutions: • The appliance is not plugged into the socket fully, or not enough to make contact. The machine does not switch on. - Page 14 The machine is noisy. • There will always be some motor, pump and drum noise during spin. The machine wont spin properly. • Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly.
-
Page 15: Assistance
OR NON-DOMESTIC PREMISES. 5 Year Parts Guarantee Hotpoint also offers you a free 5 year parts guarantee. This additional guarantee is conditional on you registering your appliance with us and the parts being fitted by one of our authorised engineers. There will be a charge for our engineer’s time. -
Page 16: After Sales Service
Republic of Ireland: 0818 313 413 www.hotpointservice.co.uk Appliance Registration We want to give you additional benefits of Hotpoint ownership. To activate your free 5 year parts guarantee you must register your appliance with us. UK: 08448 24 24 24 Republic of Ireland: 01 230 0800 www.hotpointservice.co.uk...