Connection; Terminal Positions; Connecting Procedure - Hitachi P50T01EA User Manual

CONNECTION

Terminal Positions

[Example: 50'' models]
42'' models
( *
50'' models

Connecting Procedure

This unit is ready for various kinds of connections. Make a connection in the following steps. Be sure to turn off the
Main Power fi rst when connecting external equipments.
1. Connect Power Cord to the rear panel.
2. Connect Aerial Lead.
3. Connect your external equipments to the unit if any.
4. Connect the Power Plug to the Wall Socket.
1. Connecting Power Cord to the Rear Panel
Connect Power Cord to the unit.
*Make sure not to connect the Power Plug to the Wall Socket
until all connections are completed.
2. Connecting Aerial Lead.
There are two ways to connect Aerial Lead.
When you do not have any other external equipment:
Connect the Aerial Lead directly into the Socket at rear panel.
When you have one or more external devices to connect:
1. Use RF cable to connect between each equipment and aerial.
2. Connect the Aerial Lead to the Aerial Input socket of an
external device such as a VCR.
3. Connect the RF cable from the equipment 'Out' to the otherequipment 'In.'
4. Then, connect from the equipment 'Out' to "ANT" on the plasma screen Socket.
NOTE
If analogue and digital broadcast signals are provided from separate aerials, please use a mixer and RF cable to
connect aerial socket in order to receive both signals.
Precautions when connecting the aerial
Please use a coaxial cable which is free from interference to connect the aerial. Avoid using a parallel fl at feeder
wire as interference may occur, causing reception to be unstable and stripe noise to appear on the screen.
Avoid using indoor aerial as this may be affected by interference. Please use CATV net or outdoor aerial.
If noise appears in the picture of VHF-Low band channel, please use a double-shielded cable (not provided) for
RF LEADS to reduce the noise.
14
$
1
!
@
& ^ %
8 7 6
#
2
9
0 3 4 5
Analogue
Rear
1 Power Cord Socket
2 Aerial Socket
3 AV1
4 AV2
5 AV3
6 AV4
7 Monitor Out
8 Service use only
9 Service use only
0 Power Swivel Terminal (See
! Optical Out (Digital Audio)
@ HDMI 2
# Mini stereo for Audio
$ Common interface slot
Front
% AV5
^ Headphone terminal
& HDMI 1
* SD Memory Card slot
( Photo Input terminal
Digital
STB VCR
IN
OUT
[Example: Connecting aerial
through STB and VCR]
)
59
IN
OUT