Table of Contents
Advertisement
BASIC OPERATION (continued)
Basic TV functions
Channel selection
With the 10 Number Buttons.
Example:
•
No. 2: Press 2. The station stored in the 2nd store position will
appear.
•
No. 29: Press 2 and within 2 seconds, press 9. The station
stored in the 29th store position will appear.
Press P + or – to change to the program forward or backward.
The changing takes approx. 2 seconds.
QuickView
Q. VIEW button allows you to go back to the last selected
channel or input source.
Volume adjusting
Press
+ or – to adjust the volume. The volume level
indicator disappears after 4 seconds.
MUTE
Press
. The sound will be cut off. MUTE will display on the
screen for approx. 4 seconds.
The muting can be released by pressing
Stereo reception with the built-in tuner
The built-in tuner can receive and distinguish NICAM Stereo broadcasts automatically, provided the NICAM setting in
the menu is set to "AUTO".
NICAM stereo sound reception:
Select NICAM AUTO or OFF (in Audio menu on
When NICAM reception is available, one of the following indications will be displayed.
"NICAM ST" appears for approx. 4 seconds when a NICAM STEREO broadcast signal is
received.
"NICAM " appears for approx. 4 seconds when a NICAM MONO A broadcast signal is
received.
"NICAM / " appears for approx. 4 seconds when a NICAM MONO A and MONO B
broadcast signal is received.
This will be displayed for approx. 4 seconds when "NICAM OFF" is selected in the menu
screen.
A2 Stereo reception
"STEREO" illuminates for approx. 4 seconds when a STEREO broadcast signal is received.
NOTE
In case of bad reception, the stereo sound also can be disturbed.
Adjusting the NICAM/A2 stereo sound
Pressing
alternates between the two different audio channels (when applicable).
NICAM 2-channel sound
reception
A2 2-channel sound reception
NOTE
Sometimes if reception is poor, the NICAM/A2 stereo sound may not be received correctly. In case of 2 channel sound reception,
you can select the desired sound with
20
DISPLAY
Press
of the TV program which has a Teletext time data), etc. will
appear for approx. 4 seconds.
STATUS
Press STATUS. The clock and program information will appear,
if the information is currently available.
Still picture
Press
If the built-in tuner does not receive any signal (e.g. if no aerial
is connected or if the broadcast transmission stops) during
TV operation, this unit will switch to standby after approx. 15
minutes.
again or
+ or –.
). Select OFF if you do not want to receive NICAM sound.
24
.
. Channel number, picture size setting, clock (in case
to make a still picture. To cancel the still picture, press
again.
NOTE
Advertisement
Table of Contents
