Option Menu - Hitachi PJ-TX100W User Manual

OPTION Menu

OPTION Menu
With the OPTION menu, items shown in the table below can
be performed. Perform each operation in accordance with
the instructions in the table below.
Item
AUTO OFF
LAMP TIME
FILTER TIME
Set the time using the ▲/▼ buttons. :
Long (max. 99 minutes)
AUTO OFF
ENABLE
ex.
When the time is set to 1 to 99, the projector lamp will go off and
the power indicator begins blinking when the passed time with a
proper signal (without no-signal and an unsuitable signal) reaches
at the set time. Please refer to the section "Turning Off The Power".
Pressing the RESET button for about 3 seconds displays the LAMP
TIME menu.
Select the RESET using ▲ button to reset the timer. :
RESET CANCEL
Selecting the RESET resets the count of the lamp timer to 0.
memo Perform this function only when you have replaced the
lamp. The lamp timer counts the used time of the current lamp, to
display the messages about the lamp. Incorrect performing causes
incorrect operation of the messages.
memo About replacing the lamp, please refer to the section" Lamp".
Pressing the RESET button for about 3 seconds displays the
FILTER TIME menu.
Select the RESET using ▲ button to reset the timer. :
RESET CANCEL
Selecting the RESET resets the count of the lamp timer to 0.
memo Perform this function only when you have cleaned or
replaced the air fi lter. The fi lter timer counts the used time of the air
fi lter after cleaning or replacement, to display the messages about
the air fi lter. Incorrect performing causes incorrect operation of the
messages.
memo About caring for the air fi lter, please refer to the section "Air
Filter".
Description
Short (min. 0 minute = DISABLE)
1
Multifunctional settings
MENU [ RGB ]
PICTURE AUTO OFF
IMAGE LAMP TIME
INPUT FILTER TIME
SETUP SERVICE
SCREEN
OPTION
EASY MENU
AUTO OFF
DISABLE
0
:SELECT
0
0
0
29